S2S Stepless Steel Shafts

S2S  Stepless Steel Shafts for Irons

The S2S Stepless Steel Iron Shafts are Designed with the Best Combination of Butt to Tip Stiffness That Golfers with Better Swing Characteristics Prefer in Their Irons

  • The S2S Stepless Steel Iron Shafts are designed for golfers with a stronger than average to strong Transition, a slightly faster to aggressive swing tempo and a later to very late release.
  • S2S Stepless Steel Iron Shafts are a good selection for golfers who have preferred the feel of iron shafts like the Dynamic Gold or Rifle – but they are not as tip stiff as the Project X steel iron shafts.
  • S2S Stepless Steel Iron Shafts are for golfers who prefer a heavier total weight feel in the irons
  • Wishon Golf has created tip trimming guidelines to allow the S2S Stepless Steel Iron Shafts to play to a wider range of stiffness feel

S2S Shaft Trim Charts


  • Shaft Trimming Charts


Ratings and Reviews

VN:F [1.9.22_1171]
Rating: 4.1/5 (46 votes cast)


S2S Stepless Steel Shafts, 4.1 out of 5 based on 46 ratings


  1. Hi Tom,

    I am looking to build a new set of irons to play very close to DG X100 with the stepless shafts. I have found conflicting tipping advice to reach this profile. What is your recommendation?

    I have a chart showing tipping an extra 1/2 inch being close, but in a previous post you said 2 inches would produce an Xstiff profile.

    Thank you!

    • BEN

      For the Stepless iron shaft, you would have to add 2″ to the S flex tip trim to make it a full X. Now if you work under the premise that the X100 is a slightly softer version of an X, then you could add 1 3/4″ to the S flex tip trims to get to a slightly softer X with the Stepless. But do be careful of the lengths when you start cutting that much off the tip of the Stepless R&S combination flex shaft as you might run out of butt section depending on your final length and you could maybe have to use an extender in the butt end.


Leave a Reply to Kyle Cancel reply

Your email address will not be published. Required fields are marked *